Dragster Assembly

The 300" chassis in the jig




The rear section is 1 3/8" .083 chromoly tubing
to accommodate the 1300 lb engine




The driver's compartment is custom made.
Brent had to take different measurements for the exact fit


Spitzer Composites works on the carbon fiber body


In the middle of creating the windscreen

Finally, some progress has been made!
On the left you can see the fuel cell. Steering is complete


Radiator, brake and fuel pedals, parachute buttons mount, and reverser installed


Motor mounts, motor plate, mock transmission, and rear wing mock up have been completed


Water tank installed, another view of the mock transmission